StylPro LED Face & Neck Fresh Skin Bundle

Elevate your at-home facial routine with the StylPro LED Face & Neck Fresh Skin Bundle.

Set Contents:

StylPro Neck and Face Massager
The device targets key areas prone to fine lines and dullness using massage, heat, and LED light therapies. The red LED helps to visibly smooth the skin, while the blue LED minimises the look of puffiness. Additionally, the green LED encourages a brighter aesthetic. The appearance of pores are tightened and skin appears firmer with this multi-purpose device. Includes: STYLPRO™ Face and Neck Smoother, Protective Cap, Charging Cable - USB-C, Instruction Booklet.

StylPro Wavelength LED Face Mask
The device addresses a variety of cosmetic skin concerns with four carefully curated modes. Red (633nm) and Near Infrared (830nm) LED light therapy help to visibly firm the skin, improve the look of texture and reduce the appearance of wrinkles. Blue (415nm) light therapy promotes a clearer-looking complexion, making it suitable for people with blemish-prone skin. The fourth mode includes red, blue and near-infrared LEDs for an overall skin boost. Soft, lightweight, non-invasive and versatile, the STYLPRO Wavelength is suitable for all skin types. Includes: Wavelength LED Face Mask, USB-C Cable, 2 x Silicone Eye Comfort Pads, 2 x Adjustable Mask Straps.

StylPro Neck and Face Massager:

Please refer to the instruction booklet for device movements. 

StylPro Wavelength LED Face Mask:

How To Assemble: Remove all parts of the LED Face Mask from the packaging. This includes the remote, eye comfort pads, black straps, and LED Face Mask. Place the eye comfort pads into the eye holes and ensure they are securely attached. See ‘R’ for right and ‘L’ for left on the eye comfort pads. Attach the straps into the loops at the side of the LED Face Mask. Ensure the larger end of the strap is facing upward and secure to the crown of your head. Plug the wire attached to the LED Face Mask in to the top of the remote. The LED Face Mask will not work if the remote is not plugged into the mask.

Charging: Insert the USB-C Cable (provided) into the port at the top of the remote. Attach to a USB-C friendly power source. The battery icon will show a loading sequence when charging. If the controller fails to charge or turn on, a reset is required. Press and hold both buttons for 20 seconds and then immediately begin charging the device, the battery icon should appear. Repeat if unsuccessful.

How To Use: Once your LED Face Mask is fully assembled, place the LED Face Mask onto your face and securely attach the straps around the crown of your head. Long press the On/Off button on the remote. This will turn on to the ‘Anti-Ageing’ mode. Short press the Mode button to switch to the ‘Target’ mode. Short press the Mode button to switch to the ‘Recovery’ mode. Short press the Mode button to switch to the ‘Balance’ mode. Once you have chosen your preferred Mode, enjoy a 10 minute session. To turn off your LED Face Mask before you have completed your 10 minute session, long press the On/Off button.