Spotlight Oral Care Water Flosser with UV Steriliser

• Three different pressure modes
• UV steriliser features LED Ultraviolet Technology
• Hydro gravity ball allows 360-degree flossing
• Cleans up to 99% of bacteria in one minute
• Suitable for bridges, crowns, implants and periodontal pockets

Give your mouth a deep cleanse with the Spotlight Oral Care Water Flosser with UV Steriliser. The water flosser seeks to remove bacteria from deep between the teeth and below the gum line, where traditional flossing cannot reach.

Featuring three operating modes with different water pressures, the flosser utilises a combination of high-frequency water pulsations to effectively reduce plaque. The UV steriliser features LED Ultraviolet Technology that works to reduce bacteria, while the hydro gravity ball allows smooth, 360-degree flossing from every angle. Within one minute of use, up to 99.9% of bacteria is washed away from between the teeth and gums.

Set Contents:

• Water Flosser device with UV Steriliser
• USB charger
• Replacement tips
• User manual

Step One: Charge the unit for 4 hours prior to first use. Insert the cable into the unit and insert the adapter into a USB power outlet. Unplug the charging cable from the unit prior to filling with water and during use.

Step Two: Twist the water tank off the device and place it under the tap. Fill the tank with tepid water and twist the tank back onto the device.

Step Three: Choose a tip that is right for you. Click the tip into place.

Step Four: Power the device by using the Power button.  Press the mode button once to select UV. The UV mode will run for 1 minute and automatically switch off once the sterilisation has been completed. The built-in UV steriliser uses LED ultraviolet technology to eliminate harmful bacteria, up to 99.9% in 1 minute, ensuring optimum cleanliness with every use. If you would prefer not to use the UV mode, you can skip this step by pressing the mode button twice.

Step Five: When the sterilisation is complete and the UV light turns off, press the mode button to select your preferred flossing mode. Choose between gentle, clean and pulse for a customised flossing experience.

Step Six: Once you have chosen your preferred mode, place the tip in your mouth. To avoid water splatter, keep the tip in your mouth while the unit is on. The device will run for 2 minutes.

Step Seven: Aim the tip at your gum line and work from your back teeth to your front teeth, spraying water along the gumline. Floss both the front and back of each tooth.

Step Eight: Partially close your mouth to minimise splashing, letting the water flow out of your mouth into the sink.

Step Nine: Rinse the tip in fresh water after each use and allow to air dry.