Cleansing Brush:

• Make sure your device is fully charged. To charge your brush, pull out the small rubber cover on the bottom of the device, and connect the USB charger. ALWAYS make sure the cover is secured back onto the device once charging is complete. A full charge will take 3 hours.
• Before you begin, clean your face to remove makeup, surface dirt and pollution. The WipeOut Cleansing Cloths remove make-up with just water.
• Once your skin is clear of makeup and surface dirt, apply your cleanser onto the brush head or directly onto your skin. XO LightsOut is compatible with any cleanser.
• Wet the head of the brush slightly, and press the top button down for 2 seconds to activate the micro-sonic vibrations. Continue to press the button, to select your preferred speed.
• Press the lower button down for 2 seconds to activate the LED mode, continue to press the button to select your desired LED treatment. Both modes can operate at the same time.
• Don’t scrub. Let the micro-sonic vibrations do all the work! Glide the brush gently over your face and neck (avoiding the eye area) in small slow circular motions. The device will automatically switch off after 2 minutes. To switch off before 2 minutes, press and hold the operating buttons.
• Now rinse the brush and pat dry with a dry, clean cloth.
• Complete the routine and apply your usual creams and potions.

Cleansing Cloths: Run under warm water and allow to expand, before using circular motions to remove makeup.

Swipes: Use for anything you'd use cotton wool pads. You can use with cleanser or product but they also work with just warm water. To use with just warm water, simply wet the pads and swipe away makeup. When you're done, toss into the laundry basket and wash at 30 degrees.